Search
Close this search box.

Leaning Chimney

Leaning Chimney

Ever take a good look at the size of a chimney? Chimneys are big structures set away from the building’s exterior walls. This is because chimneys need to be at least 4 inches of solid masonry to be built correctly. This design not only requires additional space, but also adds a lot of additional weight. This weight needs to be transferred onto a larger footing to support it. 

You can think of the chimney and its footing as a big concrete rectangle. This rectangle will be top-heavy because it needs to stretch beyond the home’s roof line. This weight, along with poorly compacted soil, will eventually cause the chimney to rotate away from the house.  

Signs Of A Leaning Chimney

When your chimney is leaning, it will be off-kilter and tilting away from the house. There will be a gap between the chimney and the house, usually more pronounced toward the top of the chimney. This gap between the chimney and the house can allow rodents and rain to enter. It also offers a place for mold to form.

If your chimney is leaning, there might be leaks around the chimney when it rains. For example, you might see wet patches on the walls adjacent to the chimney. You might also see ash stains on the exterior brick. This happens because the ash is leaking instead of going up the chimney. You might also notice the smoke being pushed back into the house.

Why Chimneys Lean

Usually chimneys lean because there’s a problem with the chimney’s foundation. The following are the most common reasons for a leaning chimney:
Poor construction

Perhaps the masons weren’t competent, or the brick or mortar was of poor quality.

Age

Unfortunately, brick and mortar don’t last forever. Eventually, they’ll start to break down. Bricks tend to last a lot longer than mortar, though.

No footing

Older homes might not have footing under the chimney. Chimneys without a footing are more likely to lean away from the house.

Weak footing

Sometimes, a footing isn’t thick or deep enough to adequately support the chimney. Footinghttps://www.youtube.com/watch?v=IZ0ouPhzBM4s need to be at least 12 inches thick, 6 inches wider than the chimney, and built well below the frost line if they’re going to support all that brick and mortar.

Expansive soil

Clay-rich expansive soil swells as it soaks up moisture and shrinks as it dries out. This creates movement in the soil under the foundation and can, over time, cause a footing to sink or pull away from the house.

Soil erosion

Soil prone to erosion can create voids under the footing. If the footing sinks into the voids, the chimney could lean away from the house.

Poor drainage

Poor drainage around the chimney can cause hydrostatic pressure to build up in the soil and push against the footing, causing it to shift.

How To Fix A Leaning Chimney

Leaning chimneys can be fixed using helical piers to stabilize and bring the chimney back to maximum practical recovery. The piers are turned into the ground until they reach load-bearing soil, one pier on each side of the chimney and one in the rear. The piers on the side of the chimney will help keep it from leaning from side to side and keep it level.  The pier in the back of the chimney is there to lift that portion of the footing and rotate the chimney back into place towards the framing of the home.  This method of repair is highly effective at correcting a leaning chimney.

chimney leaning
Leaning Chimney

Contact Us Today for a Free Chimney Foundation Inspection and Estimate. All Dalinghaus chimney repairs come with a lifetime warranty

foundation repair

FREE Foundation Repair Guide

Download our free foundation repair guide for Southern California & Central Arizona homeowners.

This checklist will help you spot any common foundation problems around your home and how you can fix them.

Are you ready to learn more about what’s happening with your property's foundation?

We offer free, no-obligation foundation inspections.

Our Latest Resources and News